Ford 2.3 Turbo EFI wiring harness 1983-1988

Ford 2.3 Turbo EFI wiring harness 1983-1988

It’s also a good replacement for a factory equipped Ford 2.3L Turbo vehicles as well. This harness is emissions compliant for an OBD-I system. When this harness is used with an 1987/88 Turbo Coupe ECM, it has circuits for electric fans, fuel pump, diagnostic port, water temp/oil pressure and alternator. You will be required to use a 1987-88 Ford Thunderbird Turbo Coupe heated Oxygen sensor with this harness. Once every sensor is plugged in, you will have 3 wires to hook up (Battery feed, Ignition feed and ground). It is built in the U. With brand new OEM Ford connectors, 260 degree automotive grade GXL wire (thicker insulation than TXL wire). Harness can be used with a long tube header or stock exhaust manifold. Harness is designed to mount the ECM (48 inches from the back of the motor) under the dash. Harness can be used with 5 speed manual, or any Non-computer controlled transmission. It will work with any performance upgrades or engine diagnostic tool designed for the Ford 2.3L Turbo engine. System includes: complete instructions, an assortment of 300 degree F wire loom, harness wrap and zip ties (not bare wire like other harnesses) to give it a finished look and protection. Manufactured by the Detail Zone (a division of Ron Francis Wiring). The item “Ford 2.3 Turbo EFI wiring harness 1983-1988″ is in sale since Friday, April 24, 2009. This item is in the category “eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Fuel Inject. Controls & Parts”. The seller is “qualityautospecialties” and is located in Blacksburg, Virginia. This item can be shipped to North, South, or Latin America, all countries in Europe, Australia, Japan, South africa, New Zealand.
  • Warranty: Yes
  • Country of Manufacture: United States
  • Brand: The Detail Zone
  • Manufacturer Part Number: MG-65

Comments are closed.