The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps

Welcome To Tone Man Guitar. Tone Man Guitar prebuilt 50′s wiring kits will improve your guitars overall tone. Your sound will be stronger, tighter and improved clarity. Notes will open up. Elimination of some treble loss when you roll the volume down. Tone and volume controls are very responsive to each other and smoother. By rolling back your volume some you can clean up an over driven amp. You will not find a better product or selection. I recommend 50′s wiring for the best over tone performance. Our 59 Kit uses Paper In Oil K40Y vintage tone caps for improved overall performance. Excellent clarity, aged vintage warm and woody tones with improved sustainability. These caps are equal to or better than Bumble Bee or Vitamin Q’s. We have found no better tone cap. You will hear and feel the difference. This kit is for. Gibson or Epiphone DOT ES335 style. Plus ES330, ES345, Casino, ES339. Be sure and check component distance measurements, f hole size below and compare to your guitar. If you have a similar guitar that has the output jack located on the bottom of the guitar please add a note with the measurement from the switch to the edge of the guitar at jack location. I will need to extend the output jack wire length. Sheraton models: These models have a smaller f hole opening and will not allow a full size pot to feed thru. Suggest measuring the widest opening of the f hole before ordering for a Sheraton. What’s In The Kit. Bourn’s 500K audio taper short shaft pots (qty 4). Brass bushings, with nut and dress washer. Coarse 18 teeth spline. Paper In Oil (PIO) K40Y bridge tone cap 0.033uf. Paper In Oil (PIO) K40Y neck tone cap 0.015uf. Switchcraft 3-Way Short Toggle Switch with black tip. Carefully hand wired in secure and insulated. Vintage Gavitt Braided cloth push back wiring all wrapped with high quality shrink. Switchcraft ΒΌ inch Output Jack. Assembly Template Hard Board. All assembled except for final hook up of Pickups connections and grounds. Easy to read step by step installation instructions with a 50′s wiring diagram. Wiring harness is feed thru the f holes and requires opening in the widest part of the f hole no less than 1-3/16 to 1-1/4 inch to be able to feed the harness into the hollow body easily. Template component measurements center to center. Volume to Volume 2.5″ Switch to Neck Volume 2″. Tone to Tone 2.5″ Switch to Jack 6.5″. Volume to Tone 2.5. We add an additional 1/2 to 1 inch extra wire run between components for installation flexibility. I personally prefer Bourns potentiometers over all other brands including CTS. I have found them to be smoother, responsive and longer lasting. The very best taper available. These pots are 18 spline shaft so USA type knobs will not fit without first pinching the top of the split shaft together a little and slowly push the knob on. Epiphone and off shore type will fit fine. We do offer a line of knobs that fit. Select category knobs on left side. If you are not sure whether your guitar uses short (3/8″) or long (3/4″) shaft pots please check before ordering. Normally Pre-1977 Gibson Les Paul’s, Epiphone’s, SG’s, ES Series use short shafts. All Gibson Les Paul’s manufactured after 1976 use Long Shaft pots. This kit comes with Short Shaft. Visit our other store products to see our Long Shaft Pot harness’s. Note: If you have an imported guitar e. You may need to modify the potentiometer holes to 3/8 inch to accommodate the Bourns bushings. Although these harnesses are pre-assembled and tested they do require some soldering to connect the pickups and the output jack. A 25 30 watt soldering iron is recommended. Make sure you are comfortable with making these connections or we suggest you take this to a qualified guitar tech to complete the installation. I can not be responsible if you damage a unit. In stock means I have the parts to build. Tone Man Guitar started from my own passion for music, knowledge of electronics and 50+ years of love for the guitar. The great tone from the 50′s and 60′s guitars is what I try to achieve. I guarantee the best parts and workmanship. I believe in good communication. We Want You To Be 100% Satisfied! Gary Tone Man Guitar. The item “The 59 ES335 Gibson Epiphone DOT Style Tone Prewired Wiring Harness PIO Caps” is in sale since Sunday, April 14, 2019. This item is in the category “Musical Instruments & Gear\Guitars & Basses\Parts & Accessories\Guitar Parts\Other Guitar Parts”. The seller is “tonemanguitar1″ and is located in Noblesville, Indiana. This item can be shipped to United States, Canada, United Kingdom, China, Mexico, Germany, Japan, Brazil, France, Australia, Russian federation, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Greece, Portugal, Cyprus, Slovenia, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Austria, Bahamas, Israel, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Chile, Colombia, Costa rica, Dominican republic, Panama, Trinidad and tobago, Guatemala, El salvador, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay.
  • To Fit: Electric Guitar
  • MPN: Does Not Apply
  • Brand: Tone Man Guitar

1960′s Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel

1960's Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel

1960's Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel

1960's Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel

1960's Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel

1960′s Style harness for Fender Jazz Bass with Vitamin Q Black Candy PIO caps & Series/Parallel switch! This is my latest 1960 JB System! Basically the same as my PRO model, but with the addition of the Series/Parallel mini switch! Standard J-Bass wiring is parallel. Switching to series will give you a boost in output, and a boost in mid-range. Here are the other 3 models I also have available. Pro Model with Vitamin Q Black Candy PIO caps. Standard model with Tortoise Shell control plate. Want to modify your modern era Jazz bass and go with the early 1960′s style electronics? STARR GUITAR SYSTEMS 1960′s style replacement electronics for Fender Jazz Bass! Each set is assembled, hand wired and soldered in the USA by Dave Starr using premium parts. Upgrade your import bass electronics, or replace your old worn out parts with these premium replacement units! Included in each 1960JBPROSP system: 2 CTS stacked concentric audio pots: Bottom knob controls – 500K tone, Top knob controls – 250K volume. 2 Vitamin Q Black Candy PIO capacitors. 630v neck position and. 1 Series/Parallel mini switch. 1 Switchcraft #11 input jack with heat shrink support/protection on both terminals. 1 MOJOTONE Jazz Bass 3 Hole Control Plate, Chrome. 2 Concentric stacked knob set, with set screws. Chrome top and black bottom. 5 GAVITT USA made vintage cloth wires. 1 Wiring diagram (see photo section) Starr Guitar Systems PO Box 3132 Conroe, Texas 77305 WHO WE ARE: Starr Guitar Systems (SGS) owner Dave Starr has been playing guitar and bass professionally (WildeStarr, Vicious Rumors, and CHASTAIN) for over 30 years, and doing guitar repair for over 30 years as well. Dave has put his years of experience as a pro to come up with his own line of guitar & bass electronic upgrade systems. Recorded over 15 albums, toured the world multiple times, MTV videos, artist endorsements (currently signed with ERNIE BALL strings and EMG pickups), etc. Every SGS unit comes with all of that experience behind it… What works and what doesn’t, because Dave has pretty much seen and done it all. And, every SGS unit is custom built and assembled by hand one at a time by Dave here in his Houston Texas shop. The item “1960′s Style wiring harness for Fender Jazz Bass with PIO Caps & Series/Parallel” is in sale since Thursday, January 24, 2019. This item is in the category “Musical Instruments & Gear\Guitars & Basses\Parts & Accessories\Guitar Parts\Knobs, Jacks, Switches”. The seller is “beyondtherealmsofdeath” and is located in Conroe, Texas. This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Indonesia, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Philippines, Singapore, Switzerland, Norway, Saudi arabia, Ukraine, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Costa rica, Dominican republic, Panama, Trinidad and tobago, Guatemala, El salvador, Honduras, Jamaica, Antigua and barbuda, Aruba, Belize, Dominica, Grenada, Saint kitts and nevis, Saint lucia, Montserrat, Turks and caicos islands, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Cayman islands, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay, Russian federation.
  • Model: 1960JBPROSP
  • To Fit: Fender Jazz Bass
  • Country/Region of Manufacture: United States
  • MPN: Does Not Apply
  • Brand: Starr Guitar Systems

Vintage 1960 Gibson Les Paul Burst Wiring Harness Pots Bumblebee Caps 1958 1959

Vintage 1960 Gibson Les Paul Burst Wiring Harness Pots Bumblebee Caps 1958 1959

Vintage 1960 Gibson Les Paul Burst Wiring Harness Pots Bumblebee Caps 1958 1959

Vintage 1960 Gibson Les Paul Burst Wiring Harness Pots Bumblebee Caps 1958 1959

1960 Gibson Les Paul Standard Electronics Harness. All four pot codes are: 1346045. Original Bumble Bee caps (short legs extended). Had this harness in my R9 for over a decade. Box 57036 Los Angeles, CA 91413. The item “Vintage 1960 Gibson Les Paul Burst Wiring Harness Pots Bumblebee Caps 1958 1959″ is in sale since Monday, October 14, 2019. This item is in the category “Musical Instruments & Gear\Vintage Musical Instruments\Vintage Guitars & Basses\Parts”. The seller is “vintage_sales_inc_parts_dept” and is located in Los Angeles, California. This item can be shipped worldwide.